| MOBILE |
|
| Mobile module |
- 4G (LTE) - LTE Cat 4 150 Mbps DL, 50 Mbps UL; 3G - 21 Mbps DL, 5.76 Mbps UL; 2G - 236.8 kbps DL, 236.8 kbps UL
|
| SIM switch |
- 2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection
|
| Status |
- IMSI, ICCID, operator, operator state, data connection state, network type, bandwidth, connected band, signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, data sent/received, LAC, TAC, cell ID, ARFCN, UARFCN, EARFCN, MCC, and MNC
|
| SMS |
- SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP
|
| USSD |
- Supports sending and reading Unstructured Supplementary Service Data messages
|
| Black/White list |
- Operator black/white list (by country or separate operators)
|
| Band management |
- Band lock, Used band status display
|
| APN |
|
| Bridge |
- Direct connection (bridge) between mobile ISP and device on LAN
|
| Passthrough |
- Router assigns its mobile WAN IP address to another device on LAN
|
| ETHERNET |
|
| LAN |
- 2 x ETH ports (can be configured as WAN), 10/100 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover
|
| POE IN |
|
| PoE ports |
|
| PoE standards |
|
| POE OUT |
|
| PoE ports |
|
| PoE standards |
- 802.3af and 802.3at Alternative B
|
| PoE Max Power per Port (at PSE) |
- 24 W Max (power supply unit dependent)
|
| NETWORK |
|
| Routing |
- Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP), Policy based routing
|
| Network protocols |
- TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, SFTP, FTP, SMTP, SSL/TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SNMP, MQTT, Wake On Lan (WOL)
|
| VoIP passthrough support |
- H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
|
| Connection monitoring |
- Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection
|
| Firewall |
- Port forward, traffic rules, custom rules
|
| Firewall status page |
- View all your Firewall statistics, rules, and rule counters
|
| Ports management |
- View device ports, enable and disable each of them, turn auto-configuration on or off, change their transmission speed, and so on
|
| Network topology |
- Visual representation of your network, showing which devices are connected to which other devices
|
| DHCP |
- Static and dynamic IP allocation, DHCP Relay
|
| QoS / Smart Queue Management (SQM) |
- Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
|
| DDNS |
- Supported >25 service providers, others can be configured manually
|
| Network backup |
- VRRP, Wired options, each of which can be used as an automatic Failover
|
| Hotspot |
- Captive portal (Hotspot), internal/external Radius server, SMS authorization, internal/external landing page, walled garden, user scripts, URL parameters, user groups, individual user or group limitations, user management, 9 default customizable themes and option to upload and download customised hotspot themes
|
| SSHFS |
- Possibility to mount remote file system via SSH protocol
|
| SECURITY |
|
| Authentication |
- Pre-shared key, digital certificates, X.509 certificates, TACACS+, Radius, IP & Login attempts block
|
| Firewall |
- Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
|
| Attack prevention |
- DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
|
| VLAN |
- Port and tag-based VLAN separation
|
| Mobile quota control |
Mobile data limit, customizable period, start time, warning limit, phone number |
| WEB filter |
- Blacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
|
| Access control |
- Flexible access control of SSH, Web interface, CLI and Telnet
|
| OPC UA |
|
| Supported modes |
|
| Supported connection types |
|
| MODBUS |
|
| Supported modes |
|
| Supported connection types |
|
| Custom registers |
- MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Client functionality
|
| Supported data formats |
- 8-bit: INT, UINT; 16-bit: INT, UINT (MSB or LSB first); 32-bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
|
| DATA TO SERVER |
|
| Protocol |
- HTTP(S), MQTT, Azure MQTT
|
| Data to server |
- Extract parameters from multiple sources and different protocols, and send them all to a single server
|
| MODBUS MQTT GATEWAY |
|
| Modbus MQTT Gateway |
- Allows sending commands and receiving data from MODBUS Server through MQTT broker
|
| DNP3 |
|
| Supported modes |
|
| Supported connection |
|
| DLMS |
|
| DLMS Support |
- DLMS - standard protocol for utility meter data exchange
|
| API |
|
| Teltonika Networks Web API (beta) support |
- Expand your device's possibilities by using a set of configurable API endpoints to retrieve or change data.
|
| IOT PLATFORMS |
|
| Cloud of Things |
- Allows monitoring of: Device data, Mobile data, Network info, Availability
|
| ThingWorx |
- Allows monitoring of: WAN Type, WAN IP, Mobile Operator Name, Mobile Signal Strength, Mobile Network Type
|
| Cumulocity |
- Allows monitoring of: Device Model, Revision and Serial Number, WAN Type and IP, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength
|
| Azure IoT Hub |
- Can send device IP, Number of bytes send/received, Temperature, PIN count to Azure IoT Hub server, Mobile connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, SIM State, PIN state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type
|
| SYSTEM CHARACTERISTICS |
|
|
|
| CPU |
- Mediatek, 580 MHz, MIPS 24KEc
|
| RAM |
|
| FLASH storage |
|
| FIRMWARE / CONFIGURATION |
|
| WEB UI |
- Update FW from file, check FW on server, configuration profiles, configuration backup
|
| FOTA |
|
| RMS |
- Update FW/configuration for multiple devices at once
|
| Keep settings |
- Update FW without losing current configuration
|
| POWER |
|
| Connector |
|
| Input voltage range |
- 42.5–57.0 VDC, reverse polarity protection, voltage surge/transient protection
|
| Input voltage range for PoE |
- 42.5–57.0 VDC, reverse polarity protection, voltage surge/transient protection
|
| Power consumption |
- Idle: < 2.5 W / Max: < 6 W / PoE Max < 21 W
|
| PHYSICAL SPECIFICATION |
|
| Casing material |
|
| Dimensions (W x H x D) |
|
| Weight |
|
| Mounting options |
- Mounting Bracket (for vertical flat surface or pole mounting)
|
| OPERATING ENVIRONMENT |
|
| Operating temperature |
|
| Operating humidity |
- 10% to 90% non-condensing
|
| Ingress Protection Rating |
|
